Round steel quenching and tempering production line

The Round bar hardening and tempering furnace is professionally produced by Forever Electromechanical Manufacturers. Forever Electromechanical professional engineers customize suitable induction heating equipment according to your actual process requirements. The round steel quenching and tempering production line adopts PLC fully automatic intelligent control program, with simple operation and high production efficiency.

Introduction and characteristics of round bar heat treatment production line:

▲ The intermediate frequency power supply control system is reliable, energy-saving, low-cost, high-efficiency, and the water pipeline is made of 304 non-magnetic stainless steel.

▲ The two ends of the round steel quenching and tempering line furnace body are sealed with copper plates, and the furnace body base is made of high-strength aluminum alloy, which is durable and corrosion-resistant.

▲ Connection cable: From the power cabinet to the induction heating furnace.

▲ The sealing of the capacitor is made of an 8m thick yellow insulation board, which contains the capacitor inside

▲ Siemens PLC automatic control system with high production efficiency.

▲ When the induction heating furnace operates without load, the system will reduce to a smaller power. When the workpiece enters the induction heating furnace, the device will increase to normal operation, which can greatly reduce power consumption.

▲ Infrared thermometer controls temperature, non-contact infrared thermometer can measure the temperature of steel damage at the outlet end.